How to install your D.I.Y. single chain-wheel ebike kit
Step-By-Step
Simple to follow instructions to follow below...
Takes approx 90 minutes for easy installation
 |
|
1.) Use crank remover to remove the
nut off the cranks.
|
 |
|
2.) Use crank remover to remove the
chain wheel nut
|
 |
|
3.) Use crank remover to remove the
chain wheel and cranks
|
 |
|
4.) The distance between Rear wheel
and Button bracket must be at least
60mm for 200w-1200w
1000w needs 70mm gap
|
 |
|
5.) Remove the nut from the button
bracket
|
 |
|
6.) Remove the Axle from the
button bracket and replace
with the longer Axle.
|
 |
|
7.) Put the motor’s mounting bracket
on button bracket.
|
 |
|
8.) Put the motor on mounting bracket
|
 |
|
9.) Put the “ chain wheel on the
freewheel crank” on Axle.
|
 |
|
10.) Add some chain on the all chain
( about 5 notes)
|
 |
|
11.) Fix the cranks by crank remover
|
|
12.) Put the chain over motor’s
sprocket and adj. the motor
to the right high, make sure
the nut is fix on the right place
|
|
13.) Put the chain under motor’s
sprocket and adj. the motor to the
right high, make sure the nut is fix
on the right place
|
 |
|
14.) Put the motor throttle on the
right hand side.
|
 |
|
15.) Put the gear grip on the
left hand side
|
 |
|
16.) Plug in the throttle’s plug in
to motor side controller plug
|
 |
|
17.) Plug the batters power cord to
motor’s power cord.
Completed Electric Bike
  
 
These stage 1 kits will fit all types of bikes available 99.9% of the time.
Spindles we supply fit 68mm bottom brackets…73mm bottom brackets will
need to get a matching cup-set that is longer to fit.
|
| |
|
NEW STAGE 2 MODEL DOUBLES YOUR GEARS!
|
 | 
